HVAC Installation in Cedar Park, TX, With a 10-Year Warranty

Full-system installs in Cedar Park typically run $5,500 to $18,000 depending on tonnage, SEER tier, and ductwork condition. A 14 SEER2 single-stage system on existing ductwork sits at the low end. Variable-speed equipment with new ductwork sits at the top. We hand you a flat-rate written quote before any work.

We use Manual J load calculations that factor square footage, insulation, window load, and Texas climate instead of guessing by tonnage. Most Cedar Park homes land between 2.5 and 5 tons, but the actual number depends on the building. Our tech measures the home and ductwork in person before sizing, since an oversized system short-cycles and wears out early.

A properly installed and maintained system in Texas heat typically lasts 12 to 15 years. Heavy summer load, hard water on coils, and skipped tune-ups shorten that window. A quality system installed to spec and serviced once a year lands at the high end. Once a system passes 12 years, every repair quote should include a replace-versus-repair comparison.

Our 10-year parts and labor warranty on new installs covers both the components and the labor to install replacement parts during the warranty period, when the install is registered and the system is serviced annually. Most competitors offer 10-year parts only, with labor capped at 2 years or less. We register every install in your name on install day.

The 50 percent rule is a fair starting point: if the repair quote exceeds half the cost of replacement, replacement usually wins. Age matters too. Once a Texas system passes 12 to 15 years, repair bills tend to compound and the power bill keeps climbing. We lay both numbers out in writing so you can decide without pressure.